MilCun Training Center

Accessories for Competitors

We offer accessories you can use to upgrade your equipment. These are the same great quality components we use in our own MilCun built competition rifles. For more details or to order any item, email milcun@sympatico.ca. For installation, see Gunsmithing Services for Competitors.

Leupold Telescopic Sights

We offer a full range of Leupold scopes, with the following being our most popular. Installation extra, see Gunsmithing Services for Competitors.

Leupold Mark 4 LR/T 3.5-10 x 40 mm M1 with 30mm tube, with mil.dot or TMR reticle $1400

With illuminated mil.dot or TMR reticle $1600

Leupold Mark 4 LR/T 4.5-14 x 50 mm M1 with 30mm tube and Duplex reticle $1350

With mil. dot or TMR reticle $1500

With illuminated mil. dot or TMR reticle $1750

Accessories for Telescopic Sights

Installation extra, see Gunsmithing Services for Competitors. Complete details on MilCun turret scales at the bottom of this page.

Scope bases & rings... we sell Leupold, Nightforce, Near, Badger... and MilCun bases	Flip-up scope level MilCun replacement turret scales
Leupold Mark 4 Tactical Rings - 30 mm - $200
NEW MilCun Picatinny-Style Base (made in Canada) $165
ScopLevel brand flip-up scope level - for 30 mm scope tube $60 (Scope level for 1" tube $50)
MilCun replacement turret scales - For Leupold Vari-X III models. $100 each Available for windage replacement or elevation replacement.
MilCun replacement turret scales - For Leupold Mark 4LR/T M1 models. $150 Available for windage replacement only.

Rifle Hardware and Accessories

Where required, installation is extra, see Gunsmithing Services for Competitors.

MilCun TS1-L

Our popular Tactical Sniper Stock now available in Rutland laminate.

Unfinished stock, rough inlet for Rem 700 - $125

Finished, inlet for Rem 700 - $475

Finished, inlet for Rem 700 with adjustable cheekpiece, 3-way adjustable butt and swivel studs installed $1095

(Custom inletting for other receivers available at additional cost)

MilCun TS1
Tactical Sniper Stock in Robertson composite complete with custom cheekpiece lifter and 6-way adjustable butt plate. $1000

(Also available with auto-grade finish; installation and pillar bedding extra.)

ProtekTor Rabbit Ear Bag $60

(Fill sold separately)

H-S Precision detachable magazine assembly with two 10 round magazines for the Remington 700 action $640 (Installation extra)


MacLennan match grade stainless steel barrel. $500 (Installation extra)	MilCun muzzle brake to reduce felt recoil $150 (Installation extra)


Match grade triggers $400-$600 (Installation extra	Harris "S" Series bipod $195	Pelican travel vault with wheels $375

MilCun Turret Scales
Almost every competitor has, at one time or another, turned the windage or elevation adjustment turret in the wrong direction. You can imagine what that does to your score!

So Here is the Problem...

We think one of the reasons this is done so often is the way that the factory elevation and windage turret scales are laid out. When looking at the elevation turret of the Vari-X scope from behind the gun, you can see only the zero number and a small indistinct arrow with the letter 'U' beside it. There's just too much figuring required to come up with the correct adjustment to get the right results. Note Leupold has changed the elevation knob for the Leupold Mark IV... now it looks just like a MilCun replacement turret!

The windage turret scale is even more confusing. With it set at zero, you can see the zero number and a small indistinct arrow with the letter 'R' beside it. If you put on three minutes of right wind, the scale will read '3', which is fine. BUT... if you put on three minutes of LEFT wind, the scale will read '12'. Now try to keep track of all this and make correct adjustments in a hurry... and under stress!

And Here is the Solution... for the Leupold Vari-X

MilCun has made these adjustments simple and therefore, more likely to be done correctly. We can provide you with modified turret scales that simply replace the existing Leupold target turret scales.

The elevation scale now has numbers on every major adjustment line.
	Need more elevation? Go to a higher number.
	Need less elevation? Go to a lower number.
The windage scale has two rows of numbers.
	The left row is for left wind. Need more left wind? Go to a higher number. Need less left wind? Go to a lower number.
	The right row is for right wind. Need more right right wind? Use a higher number. Need less right wind? Use a lower number.

MilCun replacement turret scales - For Leupold Vari-X III models. $100 each
Available for windage or elevation replacement.

And for the Leupold Mark 4...

MilCun replacement turret scales - For Leupold Mark 4 LR/T M1 models. $150 each
Available for windage replacement only.

MilCun continues to provide YOU with
the little things that make the BIG difference!

MilCun Mag Boot fitted on to a 20-round mag

MilCun Magazine Boots

Convert your 20-round mags to 30-round length!

Service Rifle Competition in Canada allows the use of a magazine that is the length of a 30-round magazine, a real advantage in prone and standing positions. Many competitors have the shorter 20-round mags and are competing at a disadvantage. The MilCun mag boot fits over the bottom of the mag and increases it to competition length. It also provides a more stable base and a slightly larger footprint, adding to the competitive advantage. Made of solid hard plastic. We fit the boot to your individual mags.

MilCun mag boots, fitted to your magazines (for AR-15 style rifles) - $35 each
3/$100

For more details or to order any item, email milcun@sympatico.ca.

Links For Competitors: Competitor Main Menu Competition Courses Competition Targetry Competition Rifles Competition Accessories Gunsmithing for Competitors Publications

MilCun Training Center... "Focusing on Performance"

Accessories for Competitors